This website requires JavaScript.



    All comments

    try some qd contact cleaner, tho be sure to keep it away from the led its been known to melt the led... i found that out the hard way...
    Just soak it in rubbing alcohol to dilute the ink that has gummed up the top
    bro you got there a minute before me!
    This is what I was planning to do, the ink is only in the main barrel. It is, luckily, nowhere close to the LED. Just was not sure if the rubbing alcohol would degrade the internal o-rings. Ideally, I would like to remove the bolt action mechanism.
    Thanks for the feedback.